Sea-doo 2005 3D RFI User Manual download pdf (Page 4)

CAUTION: Fuel stabilizer should be added

prior to engine lubrication to ensure fuel

system components protection against

varnish deposits.



WARNING

Fuel is flammable and explosive under

certain conditions. Always work in a well

ventilated area. Do not smoke or allow open

flames or sparks in the vicinity. Fuel tank

may be pressurized, turn cap slowly when

opening. W

hen fueling, keep watercraft level.

Do not overfill or top off the fuel tank and

leave watercraft in the sun. As temperature

increases, fuel expands and might overflow.

Always wipe off any fuel spillage from the

watercraft. Periodically inspect fuel system.

Always

turn the fuel tank valve (if so equipped)

to OFF position when storing the watercraft.

Model(

s): GTI 717

Always turn the fuel valve to O FF position

when storing the watercraft.

COOLING SYSTEM

FLUSHING

Cooling system has to be flushed with fresh

water to prevent salt, sand or dirt accumulation

which will clog water passages.

For p

roper procedure, refer to FLUSHING

in SHOP MANUAL.

F22J01A

NOTE: On the 3D RFI, the hose adapter

[

1] is located on the right hand side on

the jet pump support.

ENGINE INTERNAL

LUBRICATION

Engine must be lubricated to prevent

corrosion on internal parts.

For proper pro

cedure, refer to LUBRICATION

in SHOP MANUAL.

BATTERY

For battery removal, cleaning and storage, refer

to the appropriate SHOP MANUAL.

WATERCRAFT CLEANING

Clean the bilge with hot water and mild detergent

or with bilge cleaner. Rinse thoroughly. Lift

front end of watercraft to completely drain bilge.

If any repairs are needed to body or to the

hull, touch up pain

t and Gelcote

†

repair kits are

available. Replace damaged labels/decals.

Wash the body with soap and water solution

(use mild detergent only). Rinse thoroughly

with fresh water

. Remove marine organisms

from the hull. Apply a nonabrasive wax.

CAUTION: Never clean fiberglass and plastic

parts with strong detergent, degreasing

agent, paint th

inner, acetone, etc.

If the watercraft is to be stored outside,

cover it with an opaque tarpaulin to prevent

sun rays and grime from affecting the plastic

components, w

atercraft finish as well as

preventing dust accumulation.

CAUTION: The watercraft must never be

Ieft in water for storage. Never leave the

watercraft

stored in direct sunlight.

=> ANTIFREE

PROTECTION

In cool regions (where freezing point may be

encountered), cooling system should be filled

with pure undiluted antifreeze.

CAUTION: Antifreeze must be fed in cooling

system, otherwise remaining water will

freeze. If antifreezing is not performed

adequately, engine/exhaust system may

freeze a

nd cause severe damage.

† Gelcote is a registered trademark of Gelcote International.

4 /9 2005-11 INTERNATIONAL Service

1 2 3 4 5 6 7 8 9

Comments to this Manuals

No comments

Sea-doo 2005 3D RFI User Manual Page 4

Comments to this Manuals

EAW DX1208 manuály

Další produkty a příručky pro DVD přehrávače EAW

Sea-doo 2005 3D RFI User Manual Page 4

Comments to this Manuals

Related products and manuals for Engine Sea-doo 2005 3D RFI

EAW DX1208 manuály

Další produkty a příručky pro DVD přehrávače EAW