Sea-doo 2005 3D RFI User Manual download pdf (Page 7)

Model(s): 787 RFI Engines

Disconnect hose [2] just above T-fitting

[1] as shown.

F15E02A

21

Install a hose pincher [1] just below T-fitting.

Pour approximately 300 mL (10 oz) of antifreeze

in the water regulator valve supply hose to

allow antifreeze flowing through the valve

and into muffler to protect them.

Reconnect hose to T-fitting and remove

hose pincher (if applicable).

F15E03A

1

Model(s): All GTI's

Remove temporary hose on 717 engines and

rec

onnect engine water outlet hose.

Remove hose pinchers.

Mos

t of the antifreeze will drain out when

removing the hose pinchers. Use a container

to recover i t. DISPOSE ANTIFREEZE AS PER

YOUR LOCAL LAWS AND REGULATIONS.

NOTE: Although antifreeze will mainly drain out,

the antifreez

e has mixed with the water that

was possibly trapped in the water jackets and

thus preventing freezing problems.

At preseason preparation, drain the remaining

antifreeze f

rom cooling system prior to using

the watercraft. Ensure no hose pinchers

were forgotten at storage.

Model(s): 3D RFI

Engine and Tuned Pipe

NOTE: This procedure requires approximately

2.5 L (2.6 U

.S. qt) of antifreeze.

Remove rear access panel and engine cover. Lock

steering pole in upright position with the holder.



WARNING

Always install steering pole holder while

working in the engine compartment.

Install hose pinchers and disconnect hoses

at the lo

cations shown in photo, where [1]

indicates the engine cylinder drain hose and

[2] the heat exchanger drain hose.

F22E03A

2

1

Service 2005-11 INTERNATIONAL 7 /9

1 2 3 4 5 6 7 8 9

Comments to this Manuals

No comments