Sea-doo 2004 3D RFI Specifications download pdf (Page 40)

When safety lanyard cap is installed on

its post, the bilge pump is automati-

cally turned on. It will remain on until

all water is evacuated,then it will shut

down automatically.

When engine is running, the bilge

pump will automatically start periodi-

cally to evacuate water.

25) “Moto” Seat Release

Button

Thisbuttonisusedtounlatchthe

“moto“ seat stowed into the steering

pole.

CAUTION: Prior to using this but-

ton, ensure that the steering pole is

raised to its highest position and is

held there firmly.

NOTE: It is suggested to deploy or

stow the “moto“ seat when the wa-

tercraft is out of the water or when se-

curely docked. If this is not possible,

it should be done on calm water.

“Moto” Seat Installation



WARNING

Before installing or stowing the

“moto” seat.

- Stop the watercraft in a safe area

away from traffic or obstacles.

- Turn off engine.

- Be on the look out for other

crafts or obstacles. Your water-

craft could drift while changing

configuration.

Raise the steering pole to its highest

position and firmly hold there.

With the other hand, pull the release

button.

F22L0KY

1

1. Release button

Pull the “moto“ seat out of the steer-

ing pole.

CAUTION: Pay attention so that the

“moto“ seat does not rub against

the engine cover.

Rotate the seat out, raise and pull rear-

wards. Hold in this position.

F22L0LY

Keep the seat high enough to pull the

seat post out.

40

______________________

www.SeaDooManuals.net

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 117 118

Comments to this Manuals

No comments