Sea-doo 2004 3D RFI Specifications download pdf (Page 64)

NOTE: The quick connect adapter has

to be removed once the procedure is

completed.

Flushing and Lubrication

To flush cooling system, start the en-

gine then immediately open the water

tap.



WARNING

Components inside the engine

compartment may be hot. Keep

away from electrical parts or jet

pump area when engine is run-

ning.

CAUTION: Never flush a hot en-

gine. Always start the engine be-

fore opening the water tap. Open

the water tap immediately after en-

gine is started to prevent overheat-

ing.

Run the engine for about 3 minutes at

a fast idle around 3500 RPM.

Ensure water flows out of drain lines

(engine crankcase and engine cylinder

while flushing. Otherwise, clean the

lines.

CAUTION: Never run engine

longer than 5 minutes. The drive

line seal has no cooling when wa-

tercraft is out of water.

Spray BOMBARDIER LUBE or an

equivalent lubricant, through the hole

in the air intake silencer while keeping

engine at fast idle during one minute.

F22D01Y

2 1

1. Air intake silencer

2. Pull plug

Lubrication of engine should be done

foratleast1minute.

CAUTION: When engine begins to

run irregularly because of fuel star-

vation, immediately stop water flow

before engine dies.

Close the water tap then stop the en-

gine.

CAUTION: Always close the water

tap before stopping the engine.

Final Steps

Disconnect the garden hose.

Pull out spark plug cables and connect

them on the grounding device.



WARNING

Always use spark plug cable

grounding device when remov-

ing spark plugs.

1

F01H7DY

1. Grounding device

64

______________________

www.SeaDooManuals.net

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 117 118

Comments to this Manuals

No comments