Sea-doo 2004 3D RFI Specifications download pdf (Page 84)

F22L15Y

1

1. Tiedownsteeringpolehere

CAUTION: Trailering the watercraft

without properly tying down steer-

ing pole might result in damage to

the watercraft.

All Models

Always observe all trailering safety

precautions.

Launching/Loading

CAUTION: Before launching the

watercraft, make sure the bilge

plugs are installed and screwed in

tight. After loading the watercraft,

make sure to remove them to drain

bilge.

Storage



WARNING

Since fuel and oil are flammable,

have an authorized Sea-Doo dealer

inspect the fuel and oil systems in-

tegrity as specified in the periodic

inspection chart.

It is strongly recommended that the

watercraft be serviced by an autho-

rized Sea-Doo dealer for storage but

the following operations can be per-

formed by you with a minimum of

tools.

CAUTION: Do not run the engine

during the storage period.

Engine Draining

Check engine drain hose (lowest hose

of engine). Make sure it is free of sand

or other particles and unobstructed so

that water can drain out of the engine.

Clean hose and fitting as necessary.

CAUTION: Water in engine drain

hose should be free to flow out,

otherwise water could be trapped

in engine. Should water freeze in

engine, severe damage would oc-

cur. Check engine drain hose for

obstructions.

Disconnect the water supply hose

used to cool the magneto. It features

a quick connect fitting. Press both

tabs and pull fitting in order to discon-

nect hose.

This hose is located at the bottom of

the magneto cover beside the engine

support.

F22E02Y

1

1. Press tabs here and disconnect hose

CAUTION: Pull out fitting carefully.

Take care not to damage it against

the bilge bottom surface.

Water should flow out of the fitting

(magneto cooling circuit) and hose

(crankcase heat exchanger).

_____________________

85

www.SeaDooManuals.net

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 117 118

Comments to this Manuals

No comments