Sea-doo 2004 3D RFI Specifications download pdf (Page 38)

F22J01Y

1. Flushing connector

Refer to POST-OPERATION CARE

section for proper use.

17) Bilge Drain Plugs

Should water be found in the bilge, it

can be easily drained by unscrewing

the drain plugs when engine is off and

watercraft is out of the water.

CAUTION: Always take the water-

craft out of the water prior to un-

screwing drain plugs.

F22J01Z

1. Drain plugs

2. Tighten

3. Unscrew

Tilt the watercraft slightly to the rear

so that the water can flow out of the

bilge completely.

Itissuggestedtodrainbilgewhenthe

watercraft is on a ramp.

CAUTION: Make sure the drain

plugs are properly secured prior to

launching the watercraft in the wa-

ter.

18) Jet Pump Nozzle

Jet pump nozzle turns side to side via

rider input at the handlebar. This pro-

vides directional control when engine

is running.

F22J02Y

1. Jet pump nozzle

2. VTS adjuster

19) VTS Adjuster

A trim knob is used to change the jet

pump nozzle trim angle manually and

to adjust the ride to suit water condi-

tions and driver preferences. Refer to

illustration above.

F22J02Z

1. Trim knob

There are reference numbers to indi-

cate nozzle position and to facilitate

fine tuning.

______________________

www.SeaDooManuals.net

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 117 118

Comments to this Manuals

No comments

Sea-doo 2004 3D RFI Specifications Page 38

Comments to this Manuals

Related products and manuals for Engine Sea-doo 2004 3D RFI