Sea-doo 2004 3D RFI Specifications download pdf (Page 49)

PRE-OPERATION CHECKS



WARNING

The pre-operation check is very important prior to operating the water-

craft. Always check the proper operation of critical controls, safety fea-

tures and mechanical components, before starting as listed hereinafter. If

not done as specified here, severe injury or death might occur. Bring all

safety equipment required by local laws.

Some of the following items may not have been previously covered in this

guide, however they will be described in the MAINTENANCE or SPECIAL

PROCEDURES section. Please refer to these sections to have more detailed

information.



WARNING

Engine should be off and the safety lanyard should always be removed

from its post prior to verifying any of the following points. Only start wa-

tercraft once all items have been checked and operate properly.

ITEM

OPERATION

✓

Hull Inspect.

Jet pump water intake Inspect/clean.

Bilge Drain. Ensure plugs are secured.

Water flow in cooling system

(only when temperature is below

or close to freezing point)

Check if water properly flows out at jet pump.

Battery Inspect tightness of cables and retaining

bracket(s)

Fuel tank and oil reservoir Refill.

Engine compartment

Check fuel line connections for tightness.

Check for any fuel leak/odor.

Steering system Check operation and proper handlebar position.

Steering pole Check operation.

Throttle system

Check operation.

VTS Check position and adjustment.

Safety lanyard and engine

start/stop button

Check operation.

Optional configurations Check installation and settings.

NOTE: See the detailed instructions hereinafter.

_____________________

www.SeaDooManuals.net

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 117 118

Comments to this Manuals

No comments

Sea-doo 2004 3D RFI Specifications Page 49

Comments to this Manuals

Related products and manuals for Engine Sea-doo 2004 3D RFI